Built with Volusion
Visit our location!
150 Riberia Street
St. Augustine, FL 32085
Phone: (904) 829-2271

Check us out on
Facebook!









Home > Hoses > Hose Clamps
Sort By:
Page of 1
Stainless Steel Worm Gear Clamp 350 Series
Stainless Steel Worm Gear Clamp 350 Series

1/4" hex slotted 410 stainless steel screw, 5/16" 201/301 stainless steel band and housing. more info
Stainless Steel T-Bolt Clamps #720
Stainless Steel T-Bolt Clamps #720

Very strong and secure clamp for critical installations. Trident Marine 18-8 Stainless Steel T-Bolt Clamps are built with safety in mind. With a 3/4" (19 mm) wide 316 Stainless Steel band, this clamp ensures a greater area of coverage for a positive and strong union. It is recommended that two clamps be used on each end of a wet exhaust installation. These clamps can be used on any hose connection with piece of mind that they will last you a very long time. These clamps are sold in 2 configurations; part numbers ending in “Long” signify that a long T-Bolt is being used and is for Rubber Hose products. The part number without the “Long” is for Silicone and PVC products. "Long" signifies that it comes with a longer T-Bolt to allow a little more expansion for hose with thicker walls. more info
Constant Torque Clamps #730
Constant Torque Clamps #730

Virtually all rubber hose compresses (cold flow) after installation of clamping device, resulting in an almost immediate torque loss that can exceed 80% of installation torque. Similarly, virtually all metal connections expand as a system heats up, and then contracts as the system cools. Conventional worm gear, T-bolt, and other clamps are passive, in that expansion or contraction of components cannot be compensated for with out re-tightening or loosening the clamps. This clamping system is an “active” clamping mechanism, which monitors and then compensates for the changes by actually changing diameter through a unique worm gear Belleville assembly. more info
Scandvik ABA 304 Rubber Lined Clamp
Scandvik ABA 304 Rubber Lined Clamp

For pipes, cables, groups of cables, hoses, etc. The clamp is made of stainless steel and the edges are protected by a rubber section. Impacts and vibrations are dampened by the rubber, which also eliminates wear and tear. more info
Scandvik ABA 316 Stainless Steel Clamp
Scandvik ABA 316 Stainless Steel Clamp

Band, housing and screw are all 316 Stainless Steel. Six degree thread pitch makes it vibration proof. Rolled up band edges to minimize hose wear. No band perforations. Acid Resistant. more info
Stainless Steel Worm Gear Clamp 620 Series
Stainless Steel Worm Gear Clamp 620 Series

5/16" hex slotted high-nickel grade stainless steel screw, 1/2" high-nickel grade stainless steel band and housing. more info